The working principle of the inverter is to control the operation of the entire system through a control circuit. The inverter circuit completes the function of converting direct current to alternating current, and the filter circuit is used to filter out unwanted signals.

The work of the inverter circuit can also be refined as follows: first, the oscillating circuit converts direct current into alternating current; secondly, the coil boosts the irregular alternating current into square wave alternating current; finally, rectification makes the alternating current into a sine wave alternating current through a square wave.

The working principle of each part of the inverter

1. Input interface part: Input pars est 3 annuit, 12V DC Input Vin, Opus enable voltage enb et panel current imperium signum dim. Vin provisum est a nibh, Et in Voltage est provisum est a MCU in motherboard, and its value is 0 aut 3. Cum ENB = 0, Inverser non opus, Et cum ENB = 3, the inverter is in normal working state; while the DIM voltage Provided by the main board, the range of variation is between 0-5V. Different DIM values ​​are fed back to the feedback terminal of the PWM controller. In current provisum est a inverter ad onus erit quoque esse aliud. Minores dim valorem, the current output by the inverter. Maior.

2. Voltage start circuit: When ENB is at high level, it outputs high voltage to light the panel's backlight tube.

3. PWM Controller: Hoc est hoc munera: Internum Reference Voltage, Error Amplier, oscillator et PWM, over-voltage protection, under-voltage protection, short-circuit protection, output transistor.

4. DC conversionem: The voltage conversion circuit is composed of MOS switch tube and energy storage inductor. The input pulse is amplified by the push-pull amplifier and then drives the MOS tube to switch, so that the DC voltage can charge and discharge the inductor, so that the other end of the inductor can be Obtain AC voltage.

5. LC oscillationis et output circuitu: to ensure the 1600V voltage required for the lamp to start, and to reduce the voltage to 800V after the lamp is started.

6. Output intentione feedback: Cum onus est opus, the sampled voltage is fed back to stabilize the voltage output of the inverter